DAILY NOTES (CONTINUED)
FINAL DRIVE FILL AND LEVEL
Check oil level from outside vehicle. Fill plug access is under
B Check that oil is level with bottom of opening. If not, remove
transmission deck and fill plug (2) in final drive saddle.
C Add oil (OE/HDO or OEA), slowly, until oil flows from check
plug (1) opening.
Dry cleaning solvent (SD2) is toxic and flammable.
Wear protective goggles and gloves and use only in
D Clean level check plug (1) and fill plug (2) with solvent SD2 and
E Repeat steps A thru D for opposite side.
TRANSMISSION FILL AND LEVEL
Access is through door in transmission deck.
Do NOT check oil with engine running.
Do NOT overfill.
Always think about oil temperature when adding oil.
The oil level will vary within OPERATING RANGE due
to oil temperature.
A Check that oil level is within OPERATING RANGE on gage. Do
not add or drain oil if in this range. Add oil only when below
B Add or drain oil (OEA or OE/HDO) as required. See Note 44 for drain
C Take oil sample every 25 hours of operation or every 60 days,
whichever occurs first. Refer to DA PAM 738-750 for sampling
Card 4 of 40