DAILY NOTES (CONTINUED)
Access is through door in engine deck.
A Auxiliary Drive
1 Lift cap (1) and check oil level. Oil should be within FULL
and ADD marks on gage (2).
2 Add or drain OE/HDO or OEA, as required.
After overnight stand, oil level may indicate up to
3/4 in. (19 mm) over FULL mark. This is normal.
Step 1 deleted
2 Level should be between low (L) and full (F) marks on gage
(3). If required, add or drain oil (OE/HDO or OEA).
3 Take oil samples every 25 hours of operation or every 60
days, whichever occurs first. Refer to DA PAM 738-750 for
HYDRAULIC SYSTEM PRESSURE LINE FILTER
Make sure no personnel are in turret well before
Relieve hydraulic pressure before disassembling
Remove stowage box to gain access into turret wall.
A Check indicator button (1) on filter base (2).
B When button protrudes 1/4 in. (6 mm) the filter is dirty.
Dry cleaning solvent (SD2) is toxic and flammable.
Wear protective goggles and gloves and use only in
C Remove filter element (3) and clean inside of case (4) with sol-
D Dry case (4) and install new filter element (3).
Card 5 of 40