DAILY NOTES (CONTINUED)
Note 5
HYDRAULIC RESERVOIR
Check fluid level from inside cab, fill from outside of cab.
A Check that fluid level registers to at least halfway on level gage
(1).
CAUTION
Before opening filler cap, make sure drain groove
(2) is clear of water, dirt, and debris.
B
Open filler cap (3).
Add fluid (OE/HDO or OEA) through fill hole (4) until it registers
C
half way on level gage (1).
Note 6
MACHINE GUN AND MACHINE GUN MOUNT
Immediately after firing (or as soon as possible) thoroughly clean
and Iubricate the weapon to maintain reliability and combat effec-
tiveness. Follow the procedures Iisted below:
Disassemble the gun into the groups and assemblies. (See TM
A
9-1005-213-10).
Note
Do not dip back plate in any solution; clean with
swab or rag and CLP.
B
Clean all metal surfaces that are subject to powder fouling with
CLP. Wipe dry, and lubricate.
c
Clean bore and chamber with brush or swab, saturated with
CLP, until a clean swab can be run through the barrel without
Before assembling, inspect and clean the bolt, bolt locking area,
D
and other areas where firing residue has deposited.
Inspect each component before assembly, to ensure that lubri-
E
F
Clean all surfaces of pintle and mount with CLP; wipe dry and
lubricate pintle shaft with GAA.
Card 6 of 40
LO 9-2350-238-12
Change 1