ANNUAL NOTES (CONTINUED)
Note 52
TRAVERSING GEARCASE DRAIN AND FILL
Drain gearcase and lubricate upper section swivel joint.
Note
Drain only after operation.
A Open access door in left floor cover.
Remove upper gearcase fill plug (1).
B
Insert 1/4 in. square drive extension through gearcase
C
plug (1) and remove intermediate plug (2),
Remove cap (3) from oil drain line and drain oil into a suitable
D
container.
WARNING
Dry cleaning solvent (SD2) is toxic and flammable.
Wear protective goggles and gloves and use only in
well-ventilated area.
Clean intermediate plug (2) and drain line cap (3) with solvent
E
SD2 and install.
Remove lower section fill plug (4) and fill with oil (OEA) until it
F
reaches knurled end of gage on lower fill plug.
Fill upper section with oil (OEA) to about 1/4 in. (6 mm) below
G
top of fill hole.
Install upper gearcase fill plug (1).
H
Lubricate upper section swivel joint (5) with GAA.
I
Note 53
AUXILIARY DRIVE CLUTCH HOUSING DRAIN AND FILL
Drain oil from clutch housing.
A
Remove drain plug (1) and drain oil into a suitable container.
WARNING
I
Dry cleaning solvent (SD2) is toxic and flammable.
Wear protective goggles and gloves and use only in
well-ventilated area.
B
Clean drain plug (1) with solvent SD2 and install.
Remove fill plug (2) and add oil (OE/HDO or OEA) to full mark
C
on gage (3). -
Clean fill plug (2) with solvent SD2 and install.
D
LO 9-2350-238-12
Change 1
C a r d 30 of 40