Dry-cleaning solvent P-D-680 is toxic and
flammable. Wear protective goggles and
gloves and use only in a well-ventilated
area. Avoid contact with skin, eyes and
clothes. Do not breathe the vapors. Do not
use near open flame or excessive heat.
The flash point is 100-138 degrees F (38-
50 C). If you become dizzy while using dry-cleaning
solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with
water and get medical aid immediately.
Do not use mineral spirits or paint thinner to clean the
M88 HRV. Mineral spirits and paint thinners are highly
toxic and combustible. Prolonged breathing can cause
dizziness, nausea and even death.
Use care when removing snap and retaining rings. Snap
and retaining rings are under spring tension and can act
as projectiles when released and could cause severe eye
HIGH PRESSURE HAZARDS
Never disconnect any hydraulic line or fitting without first
dropping pressure to zero. High-pressure hydraulics
operate this equipment. Refer to vehicle operator and
maintenance manuals for hydraulic oil pressures. A high-
pressure oil stream can pierce body and cause severe
injury to personnel.