TB 9-2350-292-10
MAINTENANCE
MAINTENANCE
PROCEDURES
✔ When adjustment or service requires a
running engine, two personnel will be used; one at the
vehicle controls and the other at the service point. This
helps prevent accidental movement of controls. Failure
to comply may result in injury or death to personnel.
✔ During a slave start do not allow personnel to get
between the two vehicles. Lock brakes on vehicles and
reduce slaving vehicle engine speed to low idle (825 to
875 rpm). Failure to comply may result in injury or death
to personnel if vehicle moves.
✔ If the boom is in the full raised position, the powerpack
is removed, and the APU is non-operational, leave
boom in full raised position. Do not attempt to lower
boom. This may cause damage to boom, boom cylin-
ders and the hydraulic system.
✔ To avoid damage to the boom and hydraulic system,
always keep boom in stowed position when not in use.
✔ Some adhesives cause immediate bonding on contact
with eyes, skin, clothing and also gives off harmful
vapors. Wear protective goggles and use adhesives in
a well-ventilated area. If adhesive gets in eyes, try to
keep eyes open; flush eyes with water for 15
minutes and get immediate medical attention.
Wear safety goggles/glasses when using sealant and
avoid contact with eyes. If sealant contacts eyes,
flush eyes with water and get immediate medical
attention.
33
Change 1