• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
LIMIT SWITCH DRIVE ASSEMBLY - TEST (cont.) -834270242
LIMIT SWITCH DRIVE ASSEMBLY - ADJUST (cont.) -834270244

TM-1-1680-320-13-P High Performance Rescue Hoist Assembly P/N 42305-1NSN 1680-01-058-3671 Manual
Page Navigation
  204    205    206    207    208  209  210    211    212    213    214  
TM 1-1680-320-13&P
0034 00
HIGH PERFORMANCE RESCUE HOIST ASSEMBLY
LIMIT SWITCH DRIVE ASSEMBLY - ADJUST
INITIAL SETUP
Personnel Required: 1
References:
UH-1: 15N, Helicopter Repairer
AVUM/AVIM Manual for General Aircraft
UH-60: 15T, Helicopter Repairer
Maintenance TM 1-1500-204-23 series
Hoist Certified: 91W, Flight Medic
Parts/Materials:
N/A
Tools and Special Tools:
Tool Set, Aviation Unit Maintenance
NSN 4920-00-567-0476
Tool Kit, Aircraft Mechanic
NSN 5180-00-323-4692
Ground Power Unit (GPU)
NSN 1730-01-466-9371
Cable spool, 42277-730 or equivalent
Hex Wrench (WP 0037 00)
1. Remove cable hook assembly in accordance with WP 0015 00.
CAUTIONS
Protect hoist cable from damage. Do not allow kinks or bends to occur.
Maintain tension on cable at all times. Feed onto cable spool, coil cable into
a suitable container, or onto a protective pad, which will prevent cable
contact with ground or over abrasive surfaces.
LIMIT SWITCH adjusting screws are factory set and any attempt to adjust
will result in component failure.
NOTES
Resetting of LIMIT SWITCH operations is necessary only when:
Cable is fully extended and less than 5-7 wraps remain on drum at full stop.
The limit switch box, roller chain, or winch drum assembly are removed.
A cable installation indicates a failure of any limit switch function.
0034 00-9






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.