• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
BOOM   OPERATION
TRAVERSING   CAB

TM-9-2350-238-10 Semi Trailer Tank 5000-Gallon Fuel Dispensing Automotive M969A 2 (NSN 2330-01-377-9337) Manual
Page Navigation
  88    89    90    91    92  93  94    95    96    97    98  
TM   9-2350-238-10 OPERATING  CRANE–CONTINUED BOOM    OPERATION–CONTINUED 3 4 5 6 Release  single  boom  block  (2) from   front   of   vehicle. Do   not   continue   holding   control handle  (1)  in  RAISE  or  LOWER position   after   boom   reaches   its limits. Pull   boom   cylinder   control   handle   (3) down   to   RAISE   position   to   raise   boom. Slowly   move   boom   cylinder   control   han- dle   (3)   to   center   position   to   stop   boom cylinders. Push   boom   cylinder   control   handle   (3) forward   to   LOWER   position   to   lower boom. REEVING   BOOM   WINCH   WIRE   ROPE Normally   boom   winch   wire   rope   is   used   with single  boom  block  and  clevis  end  is  attached to   boom   to   provide   a   two-part   line   hoisting capability.  When  used  as  a  single  line  pull, wire  rope  is  detached  from  the  boom  and removed   from   single   boom   block. Always   wear   leather   gloves (item   31,   appx   B)   when   handl- ing   winch   cable.   Never   allow cable   to   run   through   hands. Broken   wires   can   cause   painful injuries.   Do   not   operate winch/crane  with  less  than  four turns   of   wire   rope   on   drums. Failure   to   observe   these   warn- ings  could  result  in  injuries  to personnel. 1  Start  hydraulic  system.  Refer  to  page 2-67. 2-77







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.