• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
IMMERSION   HEATER   OPERATION
INSTALLATION   OF   DRIVERS   ENCLOSURE

TM-9-2350-238-10 Semi Trailer Tank 5000-Gallon Fuel Dispensing Automotive M969A 2 (NSN 2330-01-377-9337) Manual
Page Navigation
  196    197    198    199    200  201  202    203    204    205    206  
TM    9-2350-238-10 WINTERIZATION   KIT–CONTINUED DRIVER‘S   ENCLOSURE   OPERATION 1 2 3 4 Pull   down   on   straps   (1)   to   lower   driver’s window   (2)   over   cupola. Secure   enclosure   by   pushing   snap   fastener on   strap   (1)   onto   studs   (3). To   open   driver’s   window: a. Pull   strap   on   each   side   of   enclosure free   from   stud. b.   Push   up   and   forward   on   window   (2) and   fold   windshield   and   window   for- ward   onto   hull. To   operate   windshield   wiper,   set   wiper motor   switch   (4),   located   to   left   of   wiper motor   (5),   to   ON   position. REMOVAL  OF  DRIVER’S  ENCLOSURE 1   Remove   window-to-cupola   chain   (1)   from base   link   (2). 2   Turn   handle   of   catch   assembly   (3) counterclockwise   until   there   is   enough slack   to   allow   release   of   catch   assembly (3)   from   latch   (4)   in   window   assembly. Lift   catch   assembly   from   latch. 3   Lift   window   (5)   from   windshield   and remove   from   vehicle. 4   Make   sure   that   windshield   is   folded   down flat. 5-8







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.