• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
NORMAL ENGINE STARTING
INSTRUMENT  PANEL  CHECKOUT  PROCEDURES

TM-9-2350-238-10 Semi Trailer Tank 5000-Gallon Fuel Dispensing Automotive M969A 2 (NSN 2330-01-377-9337) Manual
Page Navigation
  64    65    66    67    68  69  70    71    72    73    74  
TM    9-2350-238-10 NORMAL  ENGINE  STARTING–CONTINUED NOTE Before   turning   MASTER   switch ON,  make  sure  that  all  other electrical  switches  are  in  OFF position. 6   Turn   MASTER   switch   (7)   and   instru- ment   switch   (8)   to   ON.   Master   indicator light   (9)   will   light   and   warning   horn   will sound. 8 9 7  Operate   engine   fuel   filters   switch   (10) for   1   minute   to   make   sure   fuel   lines   are full. Protect   your   hearing.   Use hearing  protection  when operating   vehicle   due   to   high intensity    noise. 10 11 Do   not   operate   starter   con- tinuously”  for  over  30  seconds. Allow  a  1  -minute  cooling  off period   before   again   engaging starter.   Notify   unit   maintenance personnel  if  engine  fails  to  start on   fourth   try. Push  in  on  START  switch  (11  )  and  hold until   engine   starts,   then   release.   Warning horn  will  sound  until  engine  oil  pressure reaches   8   psi   (55   kPa), I Adjust   throttle   control   (5)   and   run   engine at   1,000   to   1,200   rpm   (fast   idle)   as   in- dicated   on   tachometer   (1   2).   Allow engine   to   warm   up   at   1,000   to   1,200 rpm   for   approximately   5   minutes. Perform   instrument   panel   checkout   pro- cedures   during   engine   warmup   period. Refer  to  page  2-54. Release  parking  brake  and  shift  transmis- sion   into   1st   range.   Drive   vehicle   slowly for  first  100  yards  (91  .4  m)  to  warm lubricants. Change 1 2-53







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.