36 Install spool (52) and winch shift rod
Refer to page 2-103 for tow winch
Hydraulic system is under high
pressure. Follow hydraulic system
safety procedures to prevent injury
(TM 9-2350-238-20-2). Wipe up
spilled hydraulic fluid.
Refer to TM 9-4940-468-14 for test setup
and testing procedures.
Connect hydraulic line (1) to inlet port of
winch control cylinder (2).
Back off two hexagon plain nuts (3 and 4)
to end of threads on winch carrier brake
Apply and hold 200 psi (1379 kpa)
pressure on winch control cylinder (2).
Tighten hexagon plain nut (3) until all
slack is taken up.
Tighten hexagon plain nut (3) an addi-
tional 1-1/2 turns, and secure hexagon
plain nut (3) in place with hexagon plain
Release hydraulic pressure and remove
hydraulic line from winch control cylinder