CORRECTIVE ACTION Continued
Place transmission selector in P (park).
Reconnect wire 14 to connector on bulkhead side of neutral safety switch. Open air inlet doors (TM
9-2350-256-10). Disconnect bulkhead to engine wiring harness and starter relay wiring harness from
bulkhead disconnect. Place red lead of multimeter on pin A of wire 14 and black lead to ground.
Turn MASTER switch on, push START switch, and check for voltage. Turn MASTER switch OFF.
If voltage is present, go to step 7. If voltage is not present, replace/repair wire 14 of switch panel to
neutral safety to bulkhead wiring harness (see WP 0203 00).