Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry contacts a metal surface a direct
short may result in instant heating of tools, damage to equipment, and injury or death to personnel.
Remove three screws (1), three lockwashers (2), two screws (3), two lockwashers (4), and ground strap
(5) and release gage panel (6) from mounting brackets. Disconnect gage panel to bulkhead wiring
harness from gage panel. Place red lead of multimeter in pin K of wire 27 and black lead to ground.
Turn MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is present, go
to step 2. If voltage is not present, go to step 3.