ITEM TO BE
a. Service hydraulic reservoir oil filter (see WP 0420 00).
b. Inspect hydraulic lines and fittings for leaks, damage, and
Class III leak present.
c. Operate system and check for unusual noises or other defects.
a. Clean and lubricate cable (refer to TM 9-2350-256-10).
a. Clean and lubricate stayline cable in accordance with WP 0097
b. Inspect boom yoke/pulley cotter pins. Replace if damaged or
Cotter pins missing or
missing (see WP 0414 00).
The unit commander or senior officer in charge
of maintenance personnel assigned to remove
and dispose of contaminated gas filters must
prescribe necessary protective clothing to
be worn during this operation. They must
also prescribe necessary safety measures to
be followed including the decontamination
operation that must be performed before new gas
filters are installed in housing assembly (refer to
a. Check that air flow is 3.0 to 4.5 standard cubic feet/minute (scf/m)
or 2.1 to 4.5 inch water gage (IWG) at each station using the M39
Tester (item 57, WP 0490 00).