SECTION V: CONTROLS AND LINKAGES
9-69 REPLACE/SERVICE DRAIN VALVE CONTROLS
THIS TASK COVERS
Tool kit, general mechanic's (Appendix C, item 53)
Powerplant removed for rear cable only (see
Rear left-side cab subfloor plate removed (see
Cloth, crocus (Appendix D, item 7)
Lockwasher (Appendix G, item 130)
Intermediate rear left-side cab subfloor plate
Lockwashers (19) (Appendix G, item 132)
removed (see paragraph 9-16)
Pins, cotter (4) (Appendix G, item 211)
Ammunition rack removed (see paragraph 9-100)
Pins, cotter (3) (Appendix G, item 212)
APU control box removed (see paragraph 13-7)
Pins, cotter (2) (Appendix G, item 217)
Prior to performing maintenance on drain valves, place a suitable container under valves
and open each valve to prevent leakage on maintenance personnel.
Disconnect front drain valve cable assembly (1) and rear drain valve cable assembly (2) from control lever assembly
(3) by removing cotter pin (4) and straight pin (5) from each.
Remove two cotter pins (6) and pin (7).
Remove ratchet (8), bracket (9), and control lever assembly (3) from control lever support assembly (10) by
removing two screws (11) and two lockwashers (12).