SECTION I: CHARGING/STARTING SYSTEM AND VEHICLE BATTERIES
TM 9-2350-256-20
b.
INSTALLATION
1
Install bracket (31) using four screws (32) and four new lockwashers (33).
2
Install starter module (27) using two screws (28), four new lockwashers (29), and two new self-locking nuts (30).
3
Connect connector (26) to starter module (27).
4
Install starter support (23) using three machine bolts (24) and three flat washers (25).
5
Install starter cradle (20) using four screws (21) and four flat washers (22).
6
Install starter (16) and new gasket (17) using three bolts (18) and three new self-locking nuts (19).
7
Secure starter (16) to starter cradle (20) using U-bolt (13), two new self-locking nuts (14), and two clamping bars (15).
8
Connect lead (10) using nut (11) and new lockwasher (12).
9
Connect two cables (7) using nut (8) and new lockwasher (9).
10 Connect ground lead (2) using machine bolt (5) and flat washer (6).
11 Connect three cables (1) and ground lead (2) using nut (3) and new lockwasher (4).
12 Install test cables and hoses. Test run engine prior to installation and check for proper starter operation.
NOTE
Follow-on maintenance:
Install powerplant (see paragraph 3-1)
6-11