TM 9-2350-256-20
CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
6-54 REPLACE/REPAIR SWITCH PANEL TO NEUTRAL SAFETY TO BULKHEAD
WIRING HARNESS (11671420)---Continued
10 Connect connector (1) to main switch panel (18).
11 Install 19 clamps (15) using new lockwasher (17) and screw (16) for each.
NOTE
Follow-on maintenance: Install air cleaner assembly (see paragraph 4-24)
6-55 REPLACE/REPAIR SWITCH PANEL TO GAGE PANEL AND
MISCELLANEOUS SWITCHES WIRING HARNESS (PASSIVE NIGHT VIEWER)
(DUAL VOLTAGE) (12322547)
THIS TASK COVERS
a. Removal
b. Disassembly
c. Assembly
d. Installation
INITIAL SET-UP
Tools:
Equipment Conditions:
Tool kit, general mechanic's (Appendix C, item 53)
Gage panel removed (see paragraph 6-8)
Switch panel removed (see paragraph 6-10)
Parts:
Lockwashers (11) (Appendix G, item 116)
WARNING
Be certain MASTER switch is OFF when working on electrical systems to avoid electrical shock and burns.
Connector No.
Electrical Lead To:
Wire No.
1
Rigger's service light switch
16
2
Dome light
38
3
Dome light
38
4
Ground
GND
5
Passive night viewer
999
6
Gage panel to bulkhead wiring harness
40
7
Driver's vehicle exhaust smoke bracket to bulkhead connection
27
wiring harness
8
Switch panel, radio, and bilge pump to bulkhead wiring
10
harness
9
Switch panel, radio, and bilge pump to bulkhead wiring
10
harness
6-124