SEC V: VEHICLE WIRING
TM 9-2350-256-20
3 Disconnect four connectors (2 through 5) from
commander's smoke activating switch (10).
b. DISASSEMBLY
Disassemble wiring harness (see Chapter 6, Section
VII).
c. ASSEMBLY
Assemble wiring harness (see Chapter 6, Section VII).
d. INSTALLATION
1 Connect four connectors (2 through 5) to
commander's smoke activating switch (10).
2 Connect connector (1) to driver's vehicle exhaust smoke disconnect bracket (9).
3 Install six clamps (6) using screw (7) and new lockwasher (8) for each.
6-95 REPLACE/REPAIR FUEL SOLENOID WIRING HARNESS (11672386)
THIS TASK COVERS
a. Removal
b. Disassembly
c. Assembly
d. Installation
INITIAL SET-UP
Tools:
Parts:
Equipment Condition:
Tools:
Parts:
Equipment Condition:
Tool kit, general mechanic's
Locknut (Appendix G,
Engine deck removed (see
(Appendix C, item 53)
item 168)
paragraph 9-51)
WARNING
Be certain MASTER switch is OFF when working on electrical systems to avoid electrical shock and bums.
6-249