SECTION I: WHEELS AND TRACKS
TM 9-2350-256-20
8 Remove inner cone bearing (24), inner oil seal (25),
and dirt deflector (26) from track support roller
bracket (27).
c. CLEANING
WARNING
Dry-cleaning solvent used to clean parts is
potentially dangerous to personnel and
property. Do not use near open flame or
excessive heat. Flashpoint of solvent is
138°F (59°C).
NOTE
Use only clean dry-cleaning solvent for bearings.
Clean all parts thoroughly using dry-cleaning solvent.
d. INSPECTION
Inspect all parts for wear, pitting, or other damage. Replace all defective parts.
e. ASSEMBLY
NOTE
Pack bearings with grease before assembling.
1 Install dirt deflector (26) and new inner oil seal (25) onto track support roller bracket (27) using replacer and
hammer.
2 Install inner cone bearing (24).
3 Install two bearing cups (23) onto hub (22) using remover, replacer, handle, and hammer.
8-17