TM 9-2350-256-34
0066 00
Disassembly
1.
Unscrew dust cap (15) and remove yoke shaft assembly (16), dust cap, split washer (17), and seal (18) from slip yoke
assembly (19). Discard seal.
2.
Remove fitting (20) from slip yoke assembly (19).
3.
Remove four snap rings (21), roller bearing assemblies (22), journal cross assembly (23), and yoke (24) from slip yoke
assembly (19). Discard snap rings.
4.
Remove four snap rings (25), roller bearing assemblies (26), journal cross assembly (27), and yoke (28) from yoke shaft
assembly (16). Discard snap rings.
Inspection-Acceptance and Rejection Criteria
1.
Inspect all parts for cracks, distortion, breakage, and other evidence of damage that would impair their use.
Assembly
Install yoke (28), journal cross assembly (27), four roller bearing assemblies (26), and snap rings (25) to yoke shaft assembly
1.
(16).
Install yoke (24), journal cross assembly (23), four roller bearing assemblies (22), and snap rings (21) to slip yoke assembly
2.
(19).
Install fitting (20) to slip yoke assembly (19).
3.
NOTE
Do not tighten dust cap during step 4.
0066 00-3