TM 9--2350--292--20--1
0222 00--2
PRIMARY FUEL FILTER REPAIR -- CONTINUED
0222 00
Removal
1. Place suitable container under fuel filter body (1). Remove nonmetallic hose assembly (2) and loosen screw in
bleeder valve (3) to drain filter body (1).
NOTE
When performing this task with engine in vehicle, it is
easier to remove outlet hose from top of fuel check valve
(next part down line from filter), take out filter with hose
attached, then remove hose. Installation should be done
in similar way.
2. Disconnect fuel filter inlet hose (4) and outlet hose (5).
CAUTION
When removing or installing filter body, be sure to avoid
damaging fluid filter line fitting. Turn filter body so fitting
will slide through bracket channel where screws and nuts
are located.
3. Remove two screws (6), two self--locking nuts (7) and slide filter body (1) out of bracket (8). Discard self--locking
nuts.
4. If new filter body (1) will be installed, remove bleeder valve (3) for installation in new unit.
Figure 29
1
2
3
4
5
6
7
8
POWERPACK
REMOVED FOR CLARITY
6