TM 9--2350--292--20--1
0227 00--2
ALIGNMENT/ADJUSTMENT OF ACCELERATOR CONTROLS AND LINKAGE
-- CONTINUED
0227 00
Adjustment (full throttle)
1. Loosen locknut (1) and adjust throttle stop screw (2) as required to obtain full throttle acceleration.
2. Tighten locknut (1).
1
2
Adjustment (hand throttle)
1. Loosen two locknuts (1) on throttle control cable (2) at accelerator connecting lever (3). Push in throttle control
handle (4) all the way.
2. Adjust two locknuts (1) until a 3/16--in. (4.76 mm) movement of throttle control handle (4) causes an increase in
engine speed with engine operating at idle.
Figure 34
1
3
4
2
NOTE
FOLLOW--ON MAINTENANCE:
Install engine deck grilles (TM 9--2350--292--10)
Install vehicular tool box rack and oddment tray
assembly (WP 0480 00)
END OF TASK