TM 9--2350--292--20--1
0267 00--1
DIRECTIONAL SIGNAL CONTROL SWITCH AND BRACKET REPLACEMENT
(OLD CONFIGURATION)
0267 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanics tool kit (item 1, WP 0717 00)
Materials/Parts
Lockwashers (2) (item 9, WP 0718 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Battery power disconnected (WP 0256 00)
Personnel Required
Two
References
TM 9--2350--292--10
Removal
1. Disconnect wiring harness 4W127 connector P2 (1) from connector J2 on directional signal control switch (2).
2. Remove clamp (3) and directional signal control switch (2) from bracket (4).
3. Remove two nuts (5), two lockwashers (6), four flat washers (7), two screws (8) and bracket (4) from vehicle. Dis-
card lockwashers.
4. Inspect parts for damage and replace as required.
Figure 80
1
2
3
4
5
6
7
7
8