TM 9--2350--292--20--1
0282 00--2
WINCH ILLUMINATION LAMP ASSEMBLY REPAIR -- CONTINUED
0282 00
Disassembly
1. Loosen three screws (7), remove lens retainer (8) from light housing (9).
2. Remove three retaining clips (10) securing headlight (11) in lens retainer (8).
3. Disconnect lead (12) from light housing (9) ground.
4. Disconnect lead (13) from electrical connector (2), remove headlight (11) from light housing (9).
5. Remove slotted washer (14) and electrical shell (15) from lead (13).
6. Remove two retaining rings (16), electrical contact (17), electrical connector (2) and nonmetallic grommet (18)
from rear of light housing (9). Discard retaining rings, electrical contact, electrical connector and nonmetallic
grommet.
7. Inspect parts for damage and replace as required.
Assembly
1. Install new nonmetallic grommet (18), new electrical connector (2), two new retaining rings (16) and new electrical
contact (17) in rear of light housing (9).
2. Install electrical shell (15) on lead (13) with slotted washer (14).
3. Connect lead (12) to light housing (9) ground.
Figure 93
7
8
11
10
12
15
13
14
16
17
16
2
18
9
10
10