TM 9--2350--292--20--1
0283 00--4
DOME LIGHT ASSEMBLY REPAIR -- CONTINUED
0283 00
Assembly
1. Install spring (41), push button (40) and setscrew (39) in switch knob (7).
2. Install connector (16) in access cover (14) with new preformed packing (38) and two screws (37).
3. Install new gasket (36), new nonmetallic seal (35), two lenses (33 and 34) and retaining plate (32) in lens retainer
(11) with seven screws (31).
4. Install partition (30) in lens retainer (11) with four screws (28) and four new lockwashers (29).
5. Install lamp assembly (27) in lens retainer (11) with two screws (25) and two flat washers (26).
6. Install lamp assembly (24) in lens retainer (11) with two screws (22) and two new lockwashers (23).
7. Connect three electrical leads (15, 19 and 20) to switch (21) with three screws (18). Install switch (21) in lens re-
tainer (11).
8. Connect electrical lead (15) to connector (16) in access cover (14).
9. Install new nonmetallic seal (17) in groove of lens retainer (11).
Figure 94
21
27
26
25
19
32
33
36
17
30
29
28
31
34
24
22
23
20
35
18
38
15
16
37
14
11
39
7
41
40
18