TM 9--2350--292--20--1
0329 00--1
LEAD ASSEMBLY 4W158 REPLACEMENT
0329 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanics tool kit (item 1, WP 0717 00)
Materials/Parts
Lockwashers (6) (item 58, WP 0718 00)
Marker tags (item 49, WP 0716 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Main switch panel removed (WP 0242 00)
References
TM 9--2350--292--10
Removal
NOTE
Tag all electrical connections and electrical leads prior to
removal to aid in installation.
1. Disconnect connector of wire 25 (1) from automotive horn (2). Cut off and discard wire connector (1) from lead
assembly (3).
2. Remove screws (4) from cable clamp (5) to disconnect attached shield wires (6).
3. Loosen shell of cable clamp (5) from hull and slide loose end of lead assembly (3) through grommet of cable
clamp (5).
4. Disconnect wire 25 (7) from horn button switch wire 25 (8).
5. Remove two screws (9), two lockwashers (10) and two clamps (11). Discard lockwashers.
6. Remove three screws (12), three lockwashers (13) and three clamps (14). Discard lockwashers.
7. Remove screw (15), lockwasher (16) and clamp (17). Discard lockwasher.
8. Inspect parts for damage and replace as required.
Installation
1. Install loose end of lead assembly (3) through grommet of cable clamp (5). Tighten shell of cable clamp (5) on
hull. Install connector of wire 25 (1) on lead assembly (3) in accordance with Wiring Harness And Cable Repair
(WP 0290 00).
2. Connect connector of wire 25 (1) to automotive horn (2).