TM 9--2350--292--20--1
0041 00--11
ENGINE FAILS TO CRANK WHEN STARTER SWTICH IS PRESSED --
CONTINUED
0041 00
Is 24 V dc present?
1. Turn MASTER switch OFF
(TM 9--2350--292--10).
2. Reconnect harness 3W132 P1 to bulkhead
disconnect.
3. Disconnect harness 3W143 P1 from engine
disconnect.
4. Turn MASTER switch ON and hold START
switch in the ON position (TM 9--2350--292--10).
5. Place multimeter red lead in pin E of
harness 3W143 P1 and black lead to ground.
Check for voltage.
6. Turn MASTER switch OFF
(TM 9--2350--292--10).
W
Repair (WP 0290 00) or
replace (WP 0293 00)
harness 3W132 lead 14.
Verify fault is corrected.
no
yes
CONTINUED FROM STEP P AND V
CONTINUED ON NEXT PAGE
Is 24 V dc present at both sockets?
1. Disconnect harness 3W207 P1 at engine
disconnect.
2. Place multimeter red lead in harness
3W207 P1 socket B and E (one at a time)
while holding black lead to ground. Check
for voltage.
X
FORWARD
no
yes
Repair (WP 0290 00) or
replace (WP 0312 00)
harness 3W710. Verify
fault is corrected.