TM 9--2350--292--20--1
0043 00--5
ENGINE CRANKS BUT WILL NOT START IN COLD WEATHER
0043 00
Is 24 V dc present?
L
no
yes
Is 24 V dc present?
1. Reconnect harness 3W143 P2.
2. Remove switch panel (WP 0242 00) and
reconnect ground strap to switch panel.
3. Disconnect harness 4W101 P1 at switch panel.
4. Turn MASTER switch ON and hold ENGINE
PREHEAT switch ON (TM 9--2350--292--10).
5. Place multimeter red lead in harness 4W101 P1
socket L and black lead to ground. Check for
voltage.
6. Release ENGINE PREHEAT switch and turn
MASTER switch OFF (TM 9--2350--292--10).
M
1. Open air intake grilles above battery
compartment (TM 9--2350--292--10).
2. Disconnect harness 3W143 P2 from bulkhead
disconnect.
3. Turn MASTER switch ON and hold ENGINE
PREHEAT switch ON (TM 9--2350--292--10).
4. Place multimeter red lead in harness 3W143
P2 socket F and black lead to ground. Check
for voltage.
5. Release ENGINE PREHEAT switch and turn
MASTER switch OFF (TM 9--2350--292--10).
Repair (WP 0290 00) or
replace (WP 0295 00)
harness 3W143. Verify
fault is corrected.
CONTINUED FROM STEP I
no
yes
Repair (WP 0290 00) or
replace (WP 0315 00)
harness 4W101. Verify
fault is corrected.
CONTINUED ON NEXT PAGE