TM 9--2350--292--20--1
0115 00--1
SERVICE HEADLIGHTS FAIL TO OPERATE.
0115 00
THIS WORK PACKAGE COVERS:
Service Headlights Fail To Operate
INITIAL SETUP:
Tools and Special Tools
General mechanics tool kit (item 1, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Personnel Required
Two
Is 24 V dc present?
1. Remove right service headlight cover and
sealed beam (WP 0275 00).
2. Turn MASTER switch and main headlight switch
to ON and auxiliary switch to any position
except PARK (TM 9--2350--292--10).
3. Place red multimeter lead in the right side of the
lamp holder socket and the black lead to
ground. Check for voltage (check left service
drive headlight).
4. Turn MASTER switch and main headlight switch
to OFF (TM 9--2350--292--10).
no
yes
Replace sealed beam
(WP 0275 00). Verify
fault is corrected.
A
NOTE
If service headlights operate on low beam
but not on high beam, go to Step C.
Left and right service headlights are checked
in the same manner, except as noted. When
testing the left service drive headlight the red
multimeter lead must be placed in the left
side of the lamp holder socket.
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
CONTINUED ON NEXT PAGE