TM 9--2350--292--20--1
0131 00--1
TURBOCHARGER DUST DETECTOR INDICATOR LIGHT FAILS TO
OPERATE.
0131 00
THIS WORK PACKAGE COVERS:
Turbocharger Dust Detector Indicator Light Fails To Operate
INITIAL SETUP:
Tools and Special Tools
General mechanics tool kit (item 1, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Engine deck removed (WP 0417 00)
Gauge panel removed from bracket (WP 0243 00)
Personnel Required
Two
Is 24 V dc present?
1. Remove lamp from turbocharger dust detector
indicator (TM 9--2350--292--10).
2. Turn MASTER switch ON
(TM 9--2350--292--10).
3. Place red multimeter lead to lamp holder
socket contact and black lead to ground.
Check for voltage.
4. Turn MASTER switch OFF
(TM 9--2350--292--10).
no
yes
no
yes
A
B
CONTINUED ON NEXT PAGE
1. Remove switch panel from bracket and
reconnect ground strap to switch panel
(WP 0242 00).
2. Disconnect lead 10 from CB6.
3. Turn MASTER switch ON
(TM 9--2350--292--10).
4. Place red multimeter lead in lead 10 CB6
connector socket and black lead to ground.
Check for voltage.
5. Turn MASTER switch OFF
(TM 9--2350--292--10).
Is 24 V dc present?
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Replace turbocharger dust
detector indicator lamp
(TM 9--2350--292--10).
Verify fault is corrected.
Go to Step F.