TM 9--2350--292--20--1
0169 00--1
SYSTEM WARNING LIGHT DOES NOT LIGHT WHEN PTO CLUTCH OIL
TEMPERATURE IS HIGH. (HIGH TEMP INDICATOR IS LIT.)
0169 00
THIS WORK PACKAGE COVERS:
System Warning Light Does Not Light When Pto Clutch Oil Temperature Is High. (High Temp Indicator Is Lit.)
INITIAL SETUP:
Tools and Special Tools
General mechanics tool kit (item 1, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Subfloor plates 26 and 27 removed (WP 0454 00)
Personnel Required
Two
1. Disconnect harness 2W601 lead 525 from
PTO high temperature switch.
2. Disconnect harness 2W601 P1 from accessory
control panel.
3. Place one multimeter lead in PTO high
temperature switch lead 525 connector and
other lead in harness 2W601 P1 socket G.
Check for continuity.
no
yes
A
B 1. Reconnect lead 525 to PTO high temperature
switch.
2. Open accessory control panel (WP 0244 00).
3. Place one multimeter lead on accessory control
panel receptacle J1 pin G and other lead on
diode T2 terminal A. Check for continuity.
WARNING
Remove rings, bracelets, wristwatches, and
neck chains before working on any vehicle.
Jewelry can catch on equipment and cause
injury, or may short across an electrical cir-
cuit and cause severe burns or electrical
shock.
Is continuity present?
Repair (WP 0290 00) or
replace (WP 0291 00)
harness 2W601. Verify
fault is corrected.
CONTINUED ON NEXT PAGE
Is continuity present?