TM 9--2350--292--20--1
0187 00--26
0187 00
PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING
LUBRICATION INSTRUCTIONS -- CONTINUED
TABLE 1 PREVENTIVE MAINTENANCE CHECKS AND SERVICES
INCLUDING LUBRICATION INSTRUCTIONS, HOURLY OR ON--CONDITION -- CONTINUED
ITEM
NO.
NOT FULLY
MISSION
CAPABLE
IF:
PROCEDURE
LOCATION
ITEM TO
CHECK/
SERVICE
INTERVAL
HOURLY (H) OR
ON--CONDITION
(OC)
BATTERY OR
ENGINE
COMPARTMENT
5
OC
Transmission and
Output Reduction
Drive Oil Change
-- Continued
o. Remove, clean and install oil filler tube
cap and gauge rod (4) onto transmission
oil filler tube.
p. Remove oil filler tube cap and gauge
rod (4) and verify that oil level is present
below the ADD mark on oil filler tube cap
and gauge rod (4). Install oil filler tube cap
and gauge rod (4) onto oil filler tube.
NOTE
Excess oil may be removed from
transmission using the AOAP
valve.
q. If indicated oil level is above FULL
mark on the oil filler tube cap and gauge
rod (4), start engine (TM 9--2350--292--10)
and remove excess oil from transmission
until oil level is indicated just below the
ADD mark on oil filler tube cap and gauge
rod (4).
NOTE
The transmission oil level is now ad-
equate to permit the engine to be
started. However, this does not
verify that oil level is adequate for
vehicle operation.
OIL GAUGE ROD
4
CHECK OIL -- ENGINE STOPPED