TM 9--2350--292--20--2
0367 00--3
BRAKE SHAFT ASSEMBLY 12364824 AND BRAKE PEDAL RETURN SPRING
REPLACEMENT (NEW CONFIGURATION WITH BRAKE MODULATION) --
CONTINUED
0367 00
Installation
1. Install two bearing housings (20) on shaft (21), tighten four set screws (24).
2. Install two lubrication fittings (23) in two bearing housings (20).
3. Lubricate two bearing housings (20) through two lubrication fittings (23) (WP 0187 00).
WARNING
NOTE
Lever on left side of shaft must be installed with side
marked X toward the left or outside of vehicle.
4. Install two levers (6 and 16) with two new retaining rings (22). Position levers (6 and 16) on shaft (21) so both
hang down after installation.
5. Install two bearing housings (20) and shaft (21) with four screws (17), four new lockwashers (19) and four flat
washers (18).
6. Install rod assembly (11) on lever (6) with straight headed pin (10), two washers (9) and new cotter pin (8).
6
8
22
10
9
11
9
20
21
23
18
19
17
22
16
20
24
18
19
17
24
13
23