TM 9--2350--292--20--2
0411 00--1
LOCKOUT BLOCK SPACERS AND BUMPER ASSEMBLIES REPLACEMENT
0411 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanics tool kit (item 1, WP 0717 00)
Torque wrench (item 2, WP 0717 00)
Materials/Parts
Lockwashers (14) (item 12, WP 0718 00)
Safety goggles (item 93, WP 0716 00)
Sealing compound (item 42, WP 0716 00)
Equipment Conditions
Armor skirt panel #1 or #6 opened
(TM 9--2350--292--10)
References
TM 9--2350--292--10
WARNING
Bumper assembly is under 3000 lbs (1362 kg) preload.
Do not remove cover or cover screws. Failure to comply
could result in personnel injury or death.
NOTE
There are four bumper assemblies, two on the front of the
vehicle and two on the rear of the vehicle. This task re-
places only one bumper assembly.
Perform Removal steps 1, 2 and 3 and Installation steps
1 through 4 for maintenance of front bumper assemblies.
Perform Removal steps 2 and 3 and Installation steps 1
through 3 for maintenance of rear bumper assemblies.
Removal
1. Remove three screws (1), two lockwashers (2), two flat washers (3) and lockout block spacer (4) from bumper
assembly (5). Discard lockwashers.
2. Remove 12 screws (6), 12 lockwashers (7) and bumper assembly (5) from vehicle. Discard lockwashers.
3. Inspect parts for damage and replace as required.
Figure 196
1
4
5
7
6
ARMOR SKIRTS REMOVED FOR CLARITY
3
2
1