TM 9--2350--292--20--2
0425 00--3
ENGINE DECK BASE ASSEMBLY REPAIR -- CONTINUED
0425 00
Assembly
1. Install spring (20), clamp (21), new lockwasher (19) and nut (18) on base assembly (6). Peen screw end of clamp
to prevent nut from falling off due to vibration.
2. Apply adhesive (item 18, Appx C) to new rubber seals (9 through 17).
3. Install new rubber seals (9 through 17) on retainers (4 and 5).
NOTE
Perform steps 4 and 5 only if fibrous glass felt is being
replaced.
4. Apply adhesive to retainers (4 and 5).
5. Install new fibrous glass felt (7 and 8) on retainers (4 and 5).
Figure 204
4
5
6
7
8
9
9
10
11
12
13
14
14
15
15
16
17
18
19
20
21