TM 9--2350--292--20--2
0354 00--6
OUTPUT REDUCTION UNIT (OUTPUT DRIVE) REPLACEMENT --
CONTINUED
0354 00
Removal--Continued
11. Install two 3/4 UNF 16 x 4 screws (24) into threaded holes (25) in output drive housing (26). Tighten both screws
(24) alternately as far as possible or until output drive (19) is supported by the suitable lifting device.
12. Carefully pull output drive (19) out of the hull until brake housing (27) is clear of hull and brake apply lever (hid-
den) is almost against inside of hull. Raise output drive until brake apply lever clears hull opening rim then pull
output drive away from hull.
Figure 165
24
25
26
19
27