LO 55-1915-200-12
LUBRICATION ORDER
30 NOVEMBER 1993
(Supersedes LO 55-1915-200-12, 11 April 1988.)
DISTRIBUTION STATEMENT A: Approved for public release; distribution is unlimited
LOGISTICS SUPPORT VESSEL (LSV)
Reference TM 55-1915-200-10, TM 55-1915-200-24&P, C 9100-IL, TM 55-1915-215-24&P
The lowest level of maintenance authorized to lubricate
Intervals (on condition or hard time) and the related
a point is indicated by one of the following:
man-hour times are based on normal operation. The
Operator/crew (C) or Organizational Maintenance (O).
man-hour time specified is the time you need to do a!!
the services prescribed for a particular interval. On-
You can help improve this manual. If you find any
condition (OC) oil sample intervals shall be applied
mistakes or if you know of a way to improve the
unless changed by the Army Oil Analysis Program
procedures, please let us know. Mail your letter or DA
(AOAP) laboratory. Change the hard time interval if
Form 2028 (Recommended Changes to Publications
your lubricants are contaminated or if you are operating
and Blank Forms) direct to Commander, U.S. Army
the equipment under adverse operating conditions,
Troop Support Command, ATTN: AMSTR-MCTS, 4300
including longer-than-usual operating hours. The hard
Goodfellow Blvd., St. Louis MO 63120-1798. A reply
time interval may be extended during periods of low
will be furnished directly to you.
activity. If extended, adequate preservation precautions
must be taken. Hard time intervals will be applied in the
'The time specified is the time required to perform all
event AOAP laboratory support is not available.
services at the particular interval.
Clean fittings before lubricating. Clean parts with DRY
CLEANING SOLVENT (SD), type II or equivalent.
Relubricate all areas exposed to water after vessel
operation. Dry before lubricating. Dotted arrow points
indicate lubrication on both sides of the equipment.
CARD 1 of 14