TM 9-2350-256-102-13. OPERATION OF AUXILIARY EQUIPMENT-Continued.(h)Bilgepump,motor,andsupportassembly.1.A bilge pump with motor and support assembly will be installed on the hull floor in the hydraulicscompartment with the deep water fording kit. The pump is used to remove water which mightenter the compartment during fording. The discharge of the pump goes through the bilge pumphose to an outlet adapter mounted on the right side of the personnel compartment. The hose andnozzle assembly can be attached to the outlet adapter to wash down the vehicle after fording.2.A toggle switch (1) and indicator lamp (2) for operating bilge pump are located on the accessoriespanel.3.A relay, which is activated by the toggle switch, controls the pump motor. A circuit breakerprovides overload protection for the pump circuit. The switch and relay coil circuit is protected bya circuit breaker in the accessories panel.(i)Ventilatingblowerhousingandboomfootdrains. A sealing plate fits into and seals the ventilatingblower airduct housing. Hose shutoff clamps are used to cut off water flow from the ventilating blowerairduct housing and boom foot drains.(j)Fireextinguishersystem. Seven rubber fire extinguisher nozzle caps stop water and contaminantsfrom entering the extinguisher system. These caps are not sealed and can be removed from thenozzles if the system is needed during fording.2-162
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
