TM 9-2350-256-20-1
0060 00
CORRECTIVE ACTION Continued
10. Reconnect bulkhead to APU, master relay, and rigger's lights wiring harness to bulkhead disconnect.
Open center-front air inlet doors (TM 9-2350-256-10). Disconnect bulkhead to APU, master relay,
and rigger's lights wiring harness from APU engine disconnect. Place red lead of multimeter on pin B
of wire 421 and black lead to ground. Turn MASTER and APU fuel shut-off switches ON and check
for voltage. Turn MASTER and APU fuel shut-off switches OFF. If voltage is present, notify Direct
Support Maintenance. If voltage is not present, repair/replace wire 421 of bulkhead to APU, master
relay, and rigger's lights wiring harness (see WP 0224 00 for dual voltage; 0225 00 for single voltage).
END OF WORK PACKAGE
0060 00-9/10 blank
