TM 9--2350--292--20--1
0085 00--3
ENGINE BATT/GEN GAUGE SHOWS NO OR INCORRECT READING --
CONTINUED
0085 00
CONTINUED FROM STEP E
F 1. Reconnect lead 25/27 to CB6.
2. Reconnect harness 4W105 P1 to switch panel.
3. Remove gauge panel from bracket (WP 0243 00).
4. Disconnect harness 4W103 P1 from gauge panel.
5. Turn MASTER switch ON
(TM 9--2350--292--10).
6. Place multimeter red lead in harness 4W103 P1
socket K and black lead to ground. Check for
voltage.
7. Turn MASTER switch OFF
(TM 9--2350--292--10).
Is 24 V dc present?
no
yes
Repair (WP 0290 00) or
replace (WP 0316 00)
harness 4W103. Verify
fault is corrected.
no
yes
Repair (WP 0290 00) or
replace (WP 0242 00)
lead 27. Verify fault is
corrected.
G
1. Reconnect harness 4W103 P1 to gauge panel.
2. Disconnect lead 27 from BATT/GEN gauge.
3. Turn MASTER switch ON
(TM 9--2350--292--10).
4. Place multimeter red lead in lead 27 gauge
connector socket and black lead to ground.
Check for voltage.
5. Turn MASTER switch OFF
(TM 9--2350--292--10).
Is 24 V dc present?
CONTINUED ON NEXT PAGE
