1 Inspect for broken, damaged, or missing parts.
2 If carrier is broken, damaged, or missing, repair is by replacement of next higher assembly.
3 Repair is by replacement of authorized parts (TM 9-23509-238-24P-2).
If retaining stop ring and spur gear
shaft were removed, new welds are
necessary during reassembly.
1 If removed, install new retaining stop ring
(1) in groove in spur gear shaft (2).
2 Insert spur gear shaft (2) into carrier (3),
seating retaining stop ring (1) firmly
Weld retaining stop ring to carrier.
Do not weld to spur gear shaft.
3 Weld retaining stop ring (1) to carrier (3)
with 0.12-in. 0.30-cm) fillet welds. Weld
three 1.00-in. (2.54-cm) spots placed an
equal distance apart around circle of re-
taining stop ring. Weld per MIL-STD-
4 Using arbor press, install three planet gear
annular ball bearings (4) in three spur