TM 1-1680-320-13&P
0018 00
WARNING
To prevent damage, use a suitable padded prying device to allow flexible
driveshaft cable to pass between support assembly and winch assembly.
NOTE
High performance rescue hoist is identified by an identification plate that is
located on right side of boomhead support assembly. If boomhead support
assembly is replaced, data plate must be transferred to new boomhead support
assembly. If identification plate is missing or damaged it must be replaced.
Original serial number must be transcribed to new identification plate. New
identification plate must be obtained from manufacturer.
4. Position boomhead support assembly (4) near winch assembly and pass flexible driveshaft (6) between upper
support assembly and winch assembly.
NOTE
Prior to completing step 2, position boomhead assembly wiring harness, between
top and lower mount bolts on left side of boomhead support assembly.
5. Install boomhead support assembly (4) onto winch assembly dowel pins.
6. Install bolts (5) and washers (7).
0018 00-9
