TM 3-1040-220-12&P
Key to figure 1-2:
1 M9 gun
2 Preformed packing
3 Hose tiedown
4 Helicopter frame tiedown
5 Snap hook and ring assembly
6 M6A2 CB mask hood (on an M17 series mask)
7 Aircraft cargo tiedown
8 Corrugated hose assembly (Helicopter delivery
hose)
9 Rubber gloves
10 Nonmetallic hose assembly (M9 gun delivery
hose)
11 Cover plate
12 Bushing
13 Rupture disk
Figure 1-3. Disperser identification plate.
14 Quick-disconnect coupling half
15 Aluminum tube
b. Other nameplates. Six nameplates (on the
16 Hose clamp
control panel) are shown in A, figure 1-4. The M9 gun
17 Corrugated hose
nameplate (B) is attached to the valve section of the M9
18 Hose clamp
gun. (The M9 gun is used on the disperser when
19 Adapter
operating the disperser from a ground vehicle).
20 Quick-disconnect coupling half
1-4.
Identification
a. Disperser. The disperser identification plate is
shown in figure 1-3. This plate is attached to the control
panel between the two compressed gas cylinders.
1-5
