TM 9-2350-256-10
CAUTION
If engine fails to start after pushing START button for 30 seconds, stop cranking,
turn off MASTER switch and wait 3 to 5 minutes. Repeat starting procedures. If
engine does not start on third try, troubleshoot (see tab. 3-1).
(e)
Depress accelerator pedal (8) to its full travel. Push START button (9).
(f)
With START button depressed, operate purge pump again and depress manifold heater switch (10).
When engine starts, stop pumping and release manifold heater switch and START button. Hold
accelerator pedal down until engine runs smooth.
NOTE
If engine fails to crank, troubleshoot (see tab. 3-1).
(g)
If engine fails to start due to low batteries, start APU (see para. 2-13e) to charge batteries or slave
start vehicle (see para. 2-10d).
2-197
