TM 9-2350-256-20-1
0042 00
CORRECTIVE ACTION Continued
5.
Reconnect switch panel to head lamps and bulkhead wiring harness to main switch panel. Install
main switch panel (5), flat washer (4), ground lead (3), three lockwashers (2), and three screws (1) to
mounting brackets. Open air inlet doors (TM 9-2350-256-10). Disconnect bulkhead to master relay
and left and right taillight wiring harness from bulkhead disconnect. Place red lead of multimeter on
pin F of wire 400 and black lead to ground. Turn MASTER switch on and check for voltage. Turn
MASTER switch OFF. Place red lead of multimeter on pin G of wire 400 and black lead to ground.
Turn MASTER switch on and check for voltage. Turn MASTER switch off. If voltage is present
replace/repair wire 459B of switch panel to head lamps and bulkhead wiring harness (see WP 0201
00). If voltage in not present, go to step 6.
0042 00-5
