TM 9-2350-256-20-1
0096 00
ITEM
INTERVAL
MAN-
ITEM TO BE
PROCEDURE
EQUIPMENT
NO.
HOUR
CHECKED OR
NOT READY
SERVICED
AVAILABLE IF:
19
S
Steering
a. With vehicle operating in moderate speed and steering control
centered, check for any tendency to wander or pull to one side. If
either of these conditions exist, check steering controls and linkage
adjustment in accordance with WP 0357 00.
20
S
Brakes
a. Accelerate vehicle to 15 miles per hour (mph) (24 kilometers per
Brakes do not operate
hour [kph] ) and do the following:
properly.
1) Release accelerator and apply brakes.
2) Observe if vehicle stops effectively without pulling
to one side. Vehicle must stop within 4 feet (ft) (1.2
meters [m] ), when stopping at 15 mph (24 kph).
b. With vehicle on an incline, do the following:
1) Depress brake pedal and move transmission shift
lever to park position.
2) Observe if brakes lock securely and vehicle is held
in place.
21
S
Transmission
a. Shift through all forward and reverse speed ranges and notice if
transmission shifts smoothly, without excessive vibration or unusual
noises, and that response is satisfactory.
22
S
Accelerator
Controls and
CAUTION
If governor malfunctions, engine speed must not
exceed 2640 rpm for more than 2 or 3 seconds.
a. Move the accelerator through its entire range and observe if
engine rpm response is satisfactory.
b. With the transmission lever in neutral position, the engine should
Idle is not between 675
idle smoothly between 675 and 725 rpm.
and 725 rpm.
c. Adjust accelerator controls and linkages in accordance with WP
0364 00.
0096 00-15
