TM 9-2350-256-20-1
0097 00
19. Mechanical transmission shaft universal joint.
a.
Remove subfloor plate (see WP 0297 00).
b.
Loosen clamp (27) and pull boot (28) out of way.
c.
Rotate joint (29) as necessary to obtain access to two grease fittings (30).
d.
Lubricate with GAA through fittings (30).
e.
Reposition boot and install subfloor plate (see WP 0297 00).
20. Breather cap-mechanical transmission.
a.
Remove subfloor plate (see WP 0297 00).
b.
Remove breather cap (31) and clean it with cleaning compound (item 9, WP 0489 00).
c.
Install cap (31).
d.
Install subfloor plate (see WP 0297 00).
21. Mechanical transmission fill and level.
a.
Remove subfloor plate (see WP 0297 00).
b.
Before operation, remove cap (31) and bayonet gage (32).
c.
Check that oil level is to the FULL mark on gage. If necessary, fill mechanical transmission with oil (see Table 2) until
FULL mark is reached.
d.
Start main engine to operate mechanical transmission for a few minutes. Stop engine and check oil level again. Add
oil, if necessary.
0097 00-22
