TM 9-2350-256-20-1
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
ENGINE AIR INLET SEAL REPLACEMENT
REMOVAL, INSTALLATION
INITIAL SETUP:
Tools and Special Tools
Materials/Parts (cont.)
Tool kit, general mechanic's (item 59, WP 0490 00)
Nuts (16) (item 768, WP 0491 00)
Washers, flat (16) (item 535, WP 0491 00)
Materials/Parts
Equipment Condition
Gaskets (2) (item 332, WP 0491 00)
Lockwashers (16) (item 639, WP 0491 00)
Engine deck removed (see WP 0336 00)
NOTE
Removal and installation procedures are the same for both the left- and right-side air inlet elbows.
Removal
1.
Remove air inlet elbow (1) by removing eight nuts (2), eight lockwashers (3), and eight flat washers (4) from studs.
2.
Remove insulation sleeving (5).
0140 00-1
