TM 9-2350-256-20-1
0148 00
NOTE
With the cleaning solution container raised to the approximate level of the surface to be cleaned and the
siphon hose extended into the container, press the air supply push button and aim the spray at the surface
to be cleaned.
NOTE
When the surface is clean, replace the cleaning solution with water and flush any cleaning solution
remaining on the surface.
NOTE
Cleaning may be accomplished with the oil cooler cleaning tool under low pressure. Care must be
exercised to ensure that no water or foreign matter enters the oil cooler opening.
Installation
1.
Install transmission thermostat (18) and gasket (19).
2.
Install two gaskets (16) and two elbows (15) by installing six self-locking nuts (17).
3.
Install engine thermostat (13) and gasket (14).
4.
Install transmission oil cooler (7) and oil cooler screen support bracket (10) by installing two flat washers (12) and four
screws (11).
0148 00-4
