TM 9-2350-256-20-2
0266 00
Servicing
1.
Clean all surfaces to remove old gasket materials.
2.
Clean filter cavity in transmission and 12 boltholes in oil filter head (3) of oil or other contaminants.
3.
Clean and dry all parts and inspect for serviceability. Replace all defective or broken parts.
Installation
1.
Install two oil filter cartridge assemblies (6).
2.
Install gasket (5) and oil filter head (3) using 12 screws (1) and 12 lockwashers (2). Torque screws to 2632 pound-feet
(lb-ft) (35-43 newtonmeters [Nm] ).
WARNING
Oil sprayed from an improperly installed oil filter head assembly can cause fire in the engine compart-
ment.
NOTE
After torquing screws (1), go back and recheck torque. If any screws move during recheck, repeat
torquing process again after a short wait.
3.
Operate engine and thoroughly check transmission (and engine) to make certain that no oil leaks are evident before placing
vehicle back into service.
NOTE
Follow-on maintenance: Close engine transmission access doors (see WP 0340 00).
END OF WORK PACKAGE
0266 00-2
